雏鹰部落

 找回密码
 立即注册

QQ登录

只需一步,快速开始

搜索
查看: 2102|回复: 4

[讨论/求助] cisco 6509 问题

[复制链接]
发表于 2011-11-2 16:55:01 | 显示全部楼层 |阅读模式
本人在升级单位的 cisco6509的IOS的时候
升级完成 show version
然后出现下面内容,多出了 红色部分

cisco WS-C6509-E (R7000) processor (revision 1.5) with 1040384K/8192K bytes of memory.
Processor board ID SMC1511003U
SR71000 CPU at 600Mhz, Implementation 1284, Rev 1.2, 512KB L2 Cache
Last reset from s/w reset
1 Virtual Ethernet interface
75 Gigabit Ethernet interfaces
2 Ten Gigabit Ethernet interfaces
1917K bytes of non-volatile configuration memory.
65536K bytes of Flash internal SIMM (Sector size 512K).
Configuration register is 0x2102

Patching is not available since the system is not running from an installed image.
To install, please use the "install file" command.


请问红色的 部分代表什么意思?? 哪个仁兄遇到过??


 楼主| 发表于 2011-11-2 17:20:50 | 显示全部楼层
没有仁兄遇到过吗? 我百度了一下,答案不是很满意
 楼主| 发表于 2011-11-3 09:19:36 | 显示全部楼层
把我的帖子顶起来。
发表于 2011-11-5 08:40:57 | 显示全部楼层
本帖最后由 onion_1999 于 2011-11-5 08:42 编辑

看下system file是否存于slot0上的lfash下,即disk0:下

Cisco建议模块安装是用内部存储,因为从supervisor的slot中能很轻易移除flash,从而导致启动不能。所以如果属于以上情况,请将file安装于sup-bootdisk0: flash下,根据自己的配置,用以下命令:
switch#install file disk0:【你的bin file name】sup-bootdisk:/sys
Source filename  【你的bin file name】?之后会看到关于bind和reload的提示,用以下命令执行bind:
switch(config)#install bind sup-bootdisk:/sys

如果你有两个supervisor engines的话,bind之后会收到warning,用以下命令拷贝installation到冗余supervisor engine上:
6500switch#install copy sup-bootdisk:/sys slavesup-bootdisk:/sys
只有一个SE的话,warning不会出现。

最后reload完事。
 楼主| 发表于 2011-11-5 13:19:41 | 显示全部楼层
明白谢谢了!!
您需要登录后才可以回帖 登录 | 立即注册

本版积分规则

QQ|熊猫同学技术论坛|小黑屋| 网络工程师论坛 ( 沪ICP备09076391 )

GMT+8, 2024-9-30 04:16 , Processed in 0.082412 second(s), 18 queries , Gzip On.

快速回复 返回顶部 返回列表