没弄懂的问题 ....关于TRUNK 的负载

heyilong

在只有100M口的两台交换机上做负载均衡   是把四条线路都用做TRUNK    来提高交换机之的带宽.......  
第一步  ： 把四个端口做成FEC...捆绑....   
第二   ：在FEC 上起 TRUNK  协议ISL 或DOT1Q.....这样做能行吗？？.  
我没试过   感觉很有用.......      大家给点建议 .........

zfh56

<P>This is the example .First ,create a channel group ,then add the port to the channel group.</P><P>F u C k&nbsp;,i can&#39;t type chinese on my computer now ,my "ziguang"can&#39;t work now .&nbsp; yumen</P><P>example:（This is the configuration in online cisco 4506)</P><P>interface Port-channel10<BR>&nbsp;switchport<BR>&nbsp;switchport trunk encapsulation dot1q<BR>&nbsp;switchport trunk allowed vlan 50,100,200,300,400<BR>&nbsp;switchport mode trunk</P><P>!</P><P>!</P><P>!</P><P>interface FastEthernet2/44<BR>&nbsp;switchport trunk encapsulation dot1q<BR>&nbsp;switchport trunk allowed vlan 50,100,200,300,400<BR>&nbsp;switchport mode trunk<BR>&nbsp;channel-group 10 mode on<BR>!<BR>interface FastEthernet2/45<BR>&nbsp;switchport trunk encapsulation dot1q<BR>&nbsp;switchport trunk allowed vlan 50,100,200,300,400<BR>&nbsp;switchport mode trunk<BR>&nbsp;channel-group 10 mode on<BR></P>

heyilong

<P>谢谢&nbsp;&nbsp;&nbsp;&nbsp; 就是这样的&nbsp;&nbsp;&nbsp; &nbsp;......</P><P>&nbsp; 你的还有配置&nbsp;&nbsp; 我去做下实验.....</P><P>&nbsp;&nbsp; </P>