雏鹰部落

 找回密码
 立即注册

QQ登录

只需一步,快速开始

搜索
查看: 2001|回复: 3

[讨论/求助] qq频繁掉线什么原因??

[复制链接]
发表于 2012-6-26 10:42:21 | 显示全部楼层 |阅读模式
这网络公司网络出现各种各样的问题,先是cisco 3825 cpu居高不下,qq频繁掉线,现在cpu降下来了,但qq还是频繁掉线,几分钟就掉一次,但我在cmd命令行中输入ping www.baidu.com -t 却不掉包,请问这是什么原因啊?

该贴已经同步到 1081302221的微博
发表于 2012-6-26 10:53:34 | 显示全部楼层
1.查看网络中是否存在ARP欺骗的。简单来说就是看看在掉线主机上看看网关的IP地址和MAC地址是否对应。可在命令行界面中使用  arp -a 命令。如果发现网关的MAC地址和真实的不一致,那可以确定网内100%存在ARP攻击行为。
2.网络环境差,ping www.baidu.com -t不掉包,你可以尝试ping 大包,例如:
  ping www.baidu.com -t -l <数据包大小>。
3.去出口设备上查看接口的信息,是否存在大量的碎桢,错误帧,丢包率是不是很大。
 楼主| 发表于 2012-6-26 12:34:45 | 显示全部楼层
victor_huang 发表于 2012-6-26 10:53
1.查看网络中是否存在ARP欺骗的。简单来说就是看看在掉线主机上看看网关的IP地址和MAC地址是否对应。可在命 ...

我几个vlan里面的主机都是这种情况,qq频繁掉线,按理说arp欺骗只会影响一个vlan里的主机啊,现在我整个网络都是这样,我查看了下我的出口路由器接口信息,也没有出现大的错误啊
Router#sh int gigabitEthernet 0/1
GigabitEthernet0/1 is up, line protocol is up
  Hardware is BCM1125 Internal MAC, address is 0019.3046.2b61 (bia 0019.3046.2b61)
  Internet address is 58.210.148.2/28
  MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
     reliability 255/255, txload 4/255, rxload 4/255
  Encapsulation ARPA, loopback not set
  Keepalive set (10 sec)
  Full-duplex, 100Mb/s, media type is RJ45
  output flow-control is XON, input flow-control is XON
  ARP type: ARPA, ARP Timeout 04:00:00
  Last input 00:00:00, output 00:00:00, output hang never
  Last clearing of "show interface" counters never
  Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 1015
  Queueing strategy: fifo
  Output queue: 0/40 (size/max)
  5 minute input rate 1705000 bits/sec, 303 packets/sec
  5 minute output rate 1881000 bits/sec, 364 packets/sec
     30121309 packets input, 2027439152 bytes, 0 no buffer
     Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
     3 input errors, 1 CRC, 0 frame, 1 overrun, 0 ignored
     0 watchdog, 3149 multicast, 0 pause input
     1 input packets with dribble condition detected
     27598557 packets output, 960472318 bytes, 0 underruns
     11 output errors, 0 collisions, 1 interface resets
     0 babbles, 0 late collision, 0 deferred
     11 lost carrier, 0 no carrier, 0 pause output
     0 output buffer failures, 0 output buffers swapped out
Router#sh int gigabitEthernet 0/0
GigabitEthernet0/0 is up, line protocol is up
  Hardware is BCM1125 Internal MAC, address is 0019.3046.2b60 (bia 0019.3046.2b60)
  Internet address is 192.168.100.254/24
  MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation ARPA, loopback not set
  Keepalive set (10 sec)
  Full-duplex, 1000Mb/s, media type is RJ45
  output flow-control is XON, input flow-control is XON
  ARP type: ARPA, ARP Timeout 04:00:00
  Last input 00:00:00, output 00:00:00, output hang never
  Last clearing of "show interface" counters never
  Input queue: 0/75/0/556 (size/max/drops/flushes); Total output drops: 249
  Queueing strategy: fifo
  Output queue: 0/40 (size/max)
  5 minute input rate 1886000 bits/sec, 358 packets/sec
  5 minute output rate 1579000 bits/sec, 285 packets/sec
     28146422 packets input, 1065788952 bytes, 0 no buffer
     Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
     0 watchdog, 1530 multicast, 0 pause input
     0 input packets with dribble condition detected
     29871775 packets output, 1988577046 bytes, 0 underruns
     7 output errors, 0 collisions, 1 interface resets
     0 babbles, 0 late collision, 0 deferred
     7 lost carrier, 0 no carrier, 0 pause output
     0 output buffer failures, 0 output buffers swapped out
 楼主| 发表于 2012-6-29 09:21:48 | 显示全部楼层
最后路由器恢复出厂设置,然后重新配置了一下就好了,现在还不知道啥原因。。。。。。
您需要登录后才可以回帖 登录 | 立即注册

本版积分规则

QQ|熊猫同学技术论坛|小黑屋| 网络工程师论坛 ( 沪ICP备09076391 )

GMT+8, 2024-11-22 17:44 , Processed in 0.093389 second(s), 18 queries , Gzip On.

快速回复 返回顶部 返回列表