|
楼主 |
发表于 2009-2-14 13:20:56
|
显示全部楼层
11. Which two multicast protocol statements are true? (Choose two.)
A. Dense mode multicast requires explicit join messages ** their members.
B. Dense mode multicast uses a push model to flood traffic throughout the network and then prunes the
unwanted traffic.
C. Sparse mode multicast uses a pull model to send multicast traffic to where it is requested.
D. Sparse mode uses reverse path forwarding (RPF) to prune off redundant flows.
E. The primary use of sparse mode multicast is for test labs and router performance testing.
Answer: BC
12. Refer to the exhibit. What is the effect on the trust boundary of configuring the command mls qos trust
cos on the switch port that is connected to the IP phone?
A. Effectively the trust boundary has been moved to the IP phone.
B. The host is now establishing the CoS value and has effectively become the trust boundary.
C. The switch is rewriting packets it receives ** the IP phone and determining the CoS value.
D. The switch will no longer tag incoming voice packets and will trust the distribution layer switch to set the
CoS.
Pass 4 side
Pass4side
Information Co., Ltd. All rights reserved.
E. RTP will be used to negotiate a CoS value based upon bandwidth utilization on the link.
Answer: A
13. Which three WLAN statements are true? (Choose three.)
A. A lightweight AP receives control and configuration ** a WLAN controller to which it is associated.
B. A WLAN client that is operating in halfduplex
mode will delay all clients in that WLAN.
C. Ad hoc mode allows mobile clients to connect directly without an intermediate AP.
D. Another term for infrastructure mode is independent service set (IBSS).
E. The Aironet 1230 access point is an example of an access point that operates solely as a lightweight
access point.
F. WLANs are designed to share the medium and can easily handle an increased demand of channel
contention.
Answer: ABC
14. Which statement is true about IP telephony calls?
A. A Voice over IP (VoIP) packet consists of the voice payload, IP header, TCP header, RTP header, and
Layer 2 link header.
B. The voice carrier stream uses H.323 to set up, maintain, and tear down call endpoints.
C. Call control signaling uses RealTime
Transport Protocol (RTP) packets that contain actual voice
samples.
D. The sum of bandwidth necessary for each major application, including voice, video, and data, should
not exceed 75 percent of the total available bandwidth for each link.
Answer: D
15. Which three statements are true about the voice VLAN feature on a Catalyst 2950 switch? (Choose
three.)
A. The CoS value is trusted for 802.1p or 802.1q tagged traffic.
B. The voice VLAN feature is disabled by default.
C. The IP phone accepts the priority of all tagged and untagged traffic and sets the CoS value to 4.
D. When the voice VLAN feature is enabled, all untagged traffic is sent according to the default CoS
priority of the port.
E. PortFast is is automatically disabled when a voice VLAN is configured.
F. The default CoS value for incoming traffic is set to 0.
Answer: BDF
Pass 4 side
Pass4side
Information Co., Ltd. All rights reserved.
16. Which statement is true about RSTP topology changes?
A. Any change in the state of the port generates a TC BPDU.
B. Only nonedge ports moving to the forwarding state generate a TC BPDU.
C. If either an edge port or a nonedge port moves to a block state, then a TC BPDU is generated.
D. Only nonedge ports moving to the blocking state generate a TC BPDU.
E. Any loss of connectivity generates a TC BPDU.
Answer: B
17. Refer to the exhibit. Which statement is true about where trust boundaries should be established in a
network?
A. Endpoint 1 is the only acceptable place to establish a trust boundary.
B. Endpoint 1 is the optimal place to establish a trust boundary. Endpoints 2 and 3 are acceptable places
to establish a trust boundary.
C. Endpoint 2 is the only acceptable place to establish a trust boundary.
D. Endpoint 2 is the optimal place to establish a trust boundary. Endpoints 1 and 3 are acceptable places
to establish a trust boundary.
E. Endpoints 1 and 2 are optimal places to establish a trust boundary. Endpoint 3 is an acceptable place
to establish a trust boundary.
F. Endpoints 2 and 3 are optimal places to establish a trust boundary. Endpoint 1 is an acceptable place to
establish a trust boundary.
Answer: E
18. Refer to the exhibit. The command spanningtree
guard root is configured on interface Gi0/0 on both
switch S2 and S5. The global configuration command spanningtree
uplinkfast has been configured on
both switch S2 and S5. The link between switch S4 and S5 fails. Will Host A be able to reach Host B?
Pass 4 side
Pass4side
Information Co., Ltd. All rights reserved.
A. Yes. Traffic can pass either ** switch S6 to S3 to S2 to S1, or, ** switch S6 to S5 to S2 to S1.
B. No. Traffic will pass ** switch S6 to S5 and deadend
at interface Gi 0/0.
C. No. Traffic will loop back and forth between switch S5 and S2.
D. Yes. Traffic will pass ** switch S6 to S3 to S2 to S1.
E. No. Traffic will either pass ** switch S6 to to S5 and deadend,
or traffic will pass ** switch S6 to
S3 to S2 and deadend.
Answer: D
19. Refer to the exhibit. A Cisco Aironet Wireless LAN Client Adapter has been installed and configured
through the ADU on the PC. The Aironet System Tray Utility (ASTU) has been enabled during the
installation and the icon appears in the system tray area in the lower right of the desktop. What is the
significance of the icon?
A. It indicates that the radio of the client adapter is disabled.
B. It indicates that the client adapter is not associated to an access point or another client.
C. It indicates that the client adapter is associated to an access point or another client, but the user is not
EAP authenticated.
D. It indicates that the client adapter is associated to an access point or another client, that the user is
authenticated if the client adapter is configured for EAP authentication, and that the signal strength is
excellent or good.
E. It indicates that the client adapter is associated to an access point or another client, that the user is
authenticated if the client adapter is configured for EAP authentication, and that the signal strength is fair.
F. It indicates that the client adapter is associated to an access point or another client, that the user is
authenticated if the client adapter is configured for EAP authentication, and that the signal strength is
Pass 4 side
Pass4side
Information Co., Ltd. All rights
reserved.
poor.
Answer: F
20. Which description correctly describes a MAC address flooding attack?
A. The attacking device crafts ARP replies intended for valid hosts. The MAC address of the attacking
device then becomes the destination address found in the Layer 2 frames sent by the valid network
device.
B. The attacking device crafts ARP replies intended for valid hosts. The MAC address of the attacking
device then becomes the source address found in the Layer 2 frames sent by the valid network device.
C. The attacking device spoofs a destination MAC address of a valid host currently in the CAM table. The
switch then forwards frames destined for the valid host to the attacking device.
D. The attacking device spoofs a source MAC address of a valid host currently in the CAM table. The
switch then forwards frames destined for the valid host to the attacking device.
E. Frames with unique, invalid destination MAC addresses flood the switch and exhaust CAM table space.
The result is that new entries cannot be **ed because of the exhausted CAM table space, and traffic is
subsequently flooded out all ports.
F. Frames with unique, invalid source MAC addresses flood the switch and exhaust CAM table space. The
result is that new entries cannot be **ed because of the exhausted CAM table space, and traffic is
subsequently flooded out all ports.
Answer: F
[ 本帖最后由 freepass4isde 于 2009-2-14 13:29 编辑 ] |
|