欧艺龙 发表于 2013-6-2 17:04:18

ppp 认证问题

为何配置后debug 不了信息-69-反复检查了。不知道什么问题。。大小写也没有错。。-71-求解。。用SHOW INT SER 0/0 也 O 的了

victor_huang 发表于 2013-6-3 09:02:18

楼主该上个图。或者贴个配置。

Jeff. 发表于 2013-6-3 09:22:45

有图才有真相啊，赶紧的。

欧艺龙 发表于 2013-6-3 22:43:56

D:\QQ图片20130603224253.jpg

欧艺龙 发表于 2013-6-3 22:49:14

不知道怎么发图。。就是两台路由器通过三serial 连在一起。。

OUMA1#show interfaces serial 0/0/0
Serial0/0/0 is up, line protocol is up (connected)
Hardware is HD64570
Internet address is 192.168.12.1/24
MTU 1500 bytes, BW 128 Kbit, DLY 20000 usec,
   reliability 255/255, txload 1/255, rxload 1/255
Encapsulation PPP, loopback not set, keepalive set (10 sec)
LCP Open
Open: IPCP, CDPCP
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0 (size/max/drops); Total output drops: 0
Queueing strategy: weighted fair
Output queue: 0/1000/64/0 (size/max total/threshold/drops)
   Conversations0/0/256 (active/max active/max total)
   Reserved Conversations 0/0 (allocated/max allocated)
   Available Bandwidth 96 kilobits/sec
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
   0 packets input, 0 bytes, 0 no buffer
   Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
   0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
   0 packets output, 0 bytes, 0 underruns
   0 output errors, 0 collisions, 1 interface resets
   0 output buffer failures, 0 output buffers swapped out
   0 carrier transitions
   DCD=upDSR=upDTR=upRTS=upCTS=up

Router#show interfaces serial 0/0/0
Serial0/0/0 is up, line protocol is up (connected)
Hardware is HD64570
Internet address is 192.168.12.2/24
MTU 1500 bytes, BW 128 Kbit, DLY 20000 usec,
   reliability 255/255, txload 1/255, rxload 1/255
Encapsulation PPP, loopback not set, keepalive set (10 sec)
LCP Open
Open: IPCP, CDPCP
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0 (size/max/drops); Total output drops: 0
Queueing strategy: weighted fair
Output queue: 0/1000/64/0 (size/max total/threshold/drops)
   Conversations0/0/256 (active/max active/max total)
   Reserved Conversations 0/0 (allocated/max allocated)
   Available Bandwidth 96 kilobits/sec
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
   0 packets input, 0 bytes, 0 no buffer
   Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
   0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
   0 packets output, 0 bytes, 0 underruns
   0 output errors, 0 collisions, 1 interface resets
   0 output buffer failures, 0 output buffers swapped out
   0 carrier transitions
   DCD=upDSR=upDTR=upRTS=upCTS=up



Router#show interfaces serial 0/0/0
Serial0/0/0 is up, line protocol is up (connected)
Hardware is HD64570
Internet address is 192.168.12.2/24
MTU 1500 bytes, BW 128 Kbit, DLY 20000 usec,
   reliability 255/255, txload 1/255, rxload 1/255
Encapsulation PPP, loopback not set, keepalive set (10 sec)
LCP Open
Open: IPCP, CDPCP
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0 (size/max/drops); Total output drops: 0
Queueing strategy: weighted fair
Output queue: 0/1000/64/0 (size/max total/threshold/drops)
   Conversations0/0/256 (active/max active/max total)
   Reserved Conversations 0/0 (allocated/max allocated)
   Available Bandwidth 96 kilobits/sec
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
   0 packets input, 0 bytes, 0 no buffer
   Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
   0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
   0 packets output, 0 bytes, 0 underruns
   0 output errors, 0 collisions, 1 interface resets
   0 output buffer failures, 0 output buffers swapped out
   0 carrier transitions
   DCD=upDSR=upDTR=upRTS=upCTS=up


Current configuration : 627 bytes
!
version 12.4
no service timestamps log datetime msec
no service timestamps debug datetime msec
no service password-encryption
!
hostname Router
!
!
!
!
!
!
!
!
username OUMA1 password 0 123
!
!
!
!
!
!
!
spanning-tree mode pvst
!
!
!
!
interface FastEthernet0/0
no ip address
duplex auto
speed auto
shutdown
!
interface FastEthernet0/1
no ip address
duplex auto
speed auto
shutdown
!
interface Serial0/0/0
ip address 192.168.12.2 255.255.255.0
encapsulation ppp
ppp authentication pap
!
interface Vlan1
no ip address
shutdown
!
ip classless
!
!
!
!
!
!
!
line con 0
!
line aux 0
!
line vty 0 4
login
!
!
!
end




因为快断电了。。有点乱。。。不好意思
就是debug 不了。。

王晓强 发表于 2013-6-4 10:03:29

注意，PAP认证过程通过后，就不会有信息了。
需要关闭接口，再打开。打开后，需要再次认证，就会看到debug信息。
debug ppp authentication

欧艺龙 发表于 2013-6-4 10:05:14

王晓强 发表于 2013-6-4 10:03
注意，PAP认证过程通过后，就不会有信息了。
需要关闭接口，再打开。打开后，需要再次认证，就会看到debug ...

万分感谢-lol--lol-
页: [1]
查看完整版本: ppp 认证问题