几个问题 ~~~谢谢~~~~
关于CCNA2 的2个问题 不明白 希望大侠帮助感激不尽!
1.
Refer to the exhibit. Which command will allow Router2 to learn about the 192.168.16.0/28 network?
Router1(config)# ip classless
Router1(config-router)# network 192.168.16.0
Router1(config-router)# no passive-interface serial 0/1/1
Router2(config-router)# version 2
Router2(config-router)# neighbor 10.0.0.2
2.
Refer to the exhibit. The exhibited network contains a mixture of Cisco and non-Cisco routers. The command
debug ip rip was entered on the JAX router. All routers are running the same version of RIP. Router CHI and
Router ORL are not able to reach the 192.168.1.16/28 network. What is a possible solution to this problem?
Enable split horizon in the network.
Configure RIPv2 on routers.
Add network 192.168.1.0 to the RIP configuration on the JAX router.
Configure JAX Fa0/0 as a passive interface.
Enable the Serial0/0/0 interface on the JAX router.
Change the IP address on the Fa0/0 interface of the JAX router to 192.168.1.1/24.
[ 本帖最后由 I.83 于 2008-11-23 02:42 编辑 ] 为什么无法显示图片??? 这两个题目都是CCNA2 chapter7 的 不好意思,没有图帮不你!
你可以弄一个WORD文档~~~期待 原帖由 I.83 于 2008-11-23 02:45 发表 http://bbs.spoto.net/images/common/back.gif
为什么无法显示图片???
最近论坛在维护中哦。 第一个问题 可以从题中看出 收发都是版本2,并且在R1上只发布了10.0.0.0的网络,
所以应该继续发布192.168.10.0的网段,让R2能学习到
Router1(config-router)# network 192.168.16.0
2题应该选择,v1不支持无类的路由
Configure RIPv2 on routers
页:
[1]